Skip to content


Car Voltage Stabilizer Circuit

Volt Stabilizer

Volt Stabilizer

Welcome back to Free Circuit Dot com, I used to built the Voltage stabilizer for my car,I think ,this is a good circuit to improve your car with simple circuit.
Equipment
 1. Cap 10,000 uf 25 v = 2 option.
 2. Cap 4,700 uf 25 v = 2 option.
 3. Cap 2,200 uf 25 v = 2 option.
 4. Cap 1,000 uf 25 v = 2 option.
 5. Cap 470 uf 25 v = 2 option.
 6. Cap 0.1 uf 25 v = 2 option.
 7. Prignss sheet 1 sheet.
 8. Fuses, lamp bulbs 10 A = 1.
 9. Carton boxes, plastic or aluminum. The power amp looks like a box (aluminum heat sink better).
 10. LEVER 2.
 11. The battery memory size 8 ~ 10 mm. = 1 meter, it’s my own little (if it has good contrast but do not forget to take the battery memory).
 12. Sleeve shrink a line (the fish tail strap with battery memory. To be completed).
 . 13 = 1 red LED light bulbs.
 14. R = 100 Ohm was an option (the next leg of the LED).
Car Voltage Stabilizer Assembly

Car Voltage Stabilizer Assembly

Posted in Filter circuit, Switching regulator circuit, battery circuit. Tagged with , , , .

2 Responses

Stay in touch with the conversation, subscribe to the RSS feed for comments on this post.

  1. zulfa said

    hi, i already make this circuit for my car.
    heard it can protect car battery.
    the improvement is more pickup due to stable voltage because car voltage are shared with others equipment like ECU or radio set. car lamp also more brightness.
    it also save the fuel because engine get more voltage power to running the spark plug.

  2. admin said

    Of cause, it is simple circuit to reduce noise from generator .
    So,Your car devices is improve . I ‘m try this circuit with my toyota .

Some HTML is OK

(required)

(required, but never shared)

or, reply to this post via trackback.