100Watt MONO Audio Amplifier Circuit With TDA7294

Overview

The Circuit is designed to produce an amplifier using a TDA7294 audio integrated circuit allocation schemes for 60 watts of power.
Terminology

* Amps – something like a built-in amplifier and is designed for the delivery and provision of adequate and high maximum output directly drives speakers or fees within a certain percentage of distortion
* TDA7294 – monolithic integrated circuit in 15-watt multi-packs separately for use as audio class AB amplifier in Hi-Fi field applications such as high-profile television, home stereo powered speakers designed for short and their short-circuit protection very low noise and distortion, thermal off, mute and standby functions, not on / off noise, high performance, not Boucherot cells DMOS output stage and high operating voltage range of
* Amplifiers Class AB – operates as a class-B amplifier that almost all of the crossover distortion by removing a small amount of bias current that constantly flows through the output transistors

Circuit Explanation

100W audio amplifier circuit

Using the integrated circuit TDA7294 is best suited to operate in Hi-Fi audio applications, amplifier class AB. Sovereignty is capable of delivering both 4 ohm and 8 ohm loads, since the IC output current and a wide range of voltage. In addition, 8 ohm load with 0.1% harmonic distortion (THD) can be supplied with 50 W RMS, with the addition of sufficient power and the minimum number of components. Eliminates the presence of heat sink water temperature at a rate of 1,4 ° C / W. In standby mode, is treated with PIN-9, while the MUTE input from the pin 10 is treated. In standby mode is always a priority for the MUTE input.

The amplifier will be activated immediately, while inclusion. This is certainly connected through lessons without constantly on the supply rail. The conversion of clicks is by increasing the time constants of C5 C6 and & R4 & R3 can be eliminated. Due to internal thermal protection of the IC, the temperature at 145 ° C can cause MUTE condition and at 150 ° C, the amplifier is in standby mode. The Circuit amplifier must not be made without the presence of a radiator that internally to generate a negative supply rail is connected to be operated. In IC, the radiator of the amplifier in a grounded metal enclosure to be mounted in isolation. The maximum voltage for 8 ohm load 40V to 30V for 4 ohm loads, a transformer with 80 VA and 150 VA for two modules in a stereo amplifier rated.